Today has been all about printing. I found these walls for free. They are pretty awesome. They join via the pin-and-hole method. They can go straight, 45 degrees, and a right angle.

The above is made from two short walls and two wall ends. The wall ends are in the foreground. A short wall is about 70mm or just under 3 inches.

Here is the Thingiverse link… correct on 20/11/22: https://www.thingiverse.com/thing:3660058

Now instead of shoving as much onto the build plate as possible, I am instead going for smaller numbers, a major reason is that the filament is running short, but also because I got two walls in just over two hours.

I also printed a dozen ghouls and a dozen dwarves Huscarls.

6 thoughts on “Ghouls, Walls and Dwarves

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s