Today has been all about printing. I found these walls for free. They are pretty awesome. They join via the pin-and-hole method. They can go straight, 45 degrees, and a right angle.
The above is made from two short walls and two wall ends. The wall ends are in the foreground. A short wall is about 70mm or just under 3 inches.
Here is the Thingiverse link… correct on 20/11/22: https://www.thingiverse.com/thing:3660058
Now instead of shoving as much onto the build plate as possible, I am instead going for smaller numbers, a major reason is that the filament is running short, but also because I got two walls in just over two hours.
I also printed a dozen ghouls and a dozen dwarves Huscarls.
Bogenwald 
Nice- those walls are well designed.
Cheers,
Pete.
LikeLiked by 3 people
Reblogged this on ausevor.
LikeLike
Great sculpts, particularly the ghoul having lunch!
LikeLiked by 1 person
Nifty walls there! Do you have a link to the STLs?
LikeLiked by 1 person
I can certainly get it for you. It was free on Thingiverse so no issue with sharing it.
LikeLiked by 1 person
Here you go…sorry for the delay 🙂
https://www.thingiverse.com/thing:3660058
LikeLike
I’ve found that for Filament printing it is often to print many small parts separately than grouping a bunch together. Love the wall concept and the finished printed bits look great!
LikeLiked by 1 person