By heck I was busy this evening!

I managed to get paint on various things, including some Flintloque miniatures too. I re levelled the printer again, this time I made sure I pressed on the build plate as I screwed the bolts in, this was to make sure it was level across the whole thing. I had printed the bust and stand at the same time, but only the bust printed, now it might have been poor support placement. So after re levelling the build plate, I gave this lot a go…

They pretty much all came out fine apart from the beggar’s right foot which hadn’t really printed properly (well I don’t think it had) … so I helped out by snipping it off… oh by the way the dog does have a head, it is behind the milk maid. These are the villagers from the Frost Kickstarter.