So after another bit of time, I rescued the two bits off the print bed…

Small wonder I couldn’t work out what was what. The tree supports went everywhere. Unfortunately removing said supports caused various bits to fall off the models. In the end the bridge ended up without it’s handrails as did the Torri gate…

I don’t think that they are too bad a size. I will try again tomorrow after I have taken the village off the build plate. (Yes I am printing more 6mm houses 😂).

One thought on “Torri and Bridge an Update

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s