My daughter’s mask (or part of it) is finished.

There is still the lower jaw to do but the main bit is finished. It only took 60 hours over four sessions to print. I had to cut it into four and drop the size down to 90% to make it fit on the print bed.
I did have a. It of a problem with one of the rear pieces as it fell off before the end of the print (which I had forgotten about) and as such it doesn’t meet in part of it.

The gap is clearly visible on this photo. I will fix it with some Greenstuff. Hopefully the lower jaw isn’t too hard to print!
That’s an amazing mask mate! well done, cant wait to see it finished.
LikeLiked by 2 people
That is looking good.
Cheers,
Pete.
LikeLiked by 2 people
Very cool
LikeLike