If you remember, last night I said I was concerned that the Resin Huey had a void that could contain liquid resin. Today I drilled out the exhaust to find out. It did!

I stood it on its end to drain it out and made a rookie mistake. I forgot to drill an air hole to allow the liquid to escape easier. It oozed instead of ran and as such, I forgot about it and it has messed up the print. It really didn’t help that I forgot about it and it cured.

I have all the bits now apart from the main rotor. That will have to be done on the FDM.

I will have to sand the lump of cured resin off too.

Today has been a crap day health wise. Felt dizzy and in pain all day. Luckily I have a phone appointment with the doctor tomorrow morning.