Well my 8 hour print was successful and so was the following 6 hour one. I have a print going just now and will then need to print the rider but I am really pleased with this so far…
The 32mm skeleton will give a sense of scale. I have added green stuff to the tail and wing joint and will do the same with the right wing.
Once this is done I will slice up some cavalry for a bit of oomph and then see what I think. Bows are going to be my box of 16 GW skeletons. it would be good if I could find another six to bulk them out to two units of twelve. I could of course print some command figures to do the job for me.
Bogenwald 
Reblogged this on ausevor.
LikeLike
That is really impressive.
Cheers,
Pete.
LikeLiked by 2 people
He’s cool
LikeLiked by 2 people
That does look really good! 🙂
LikeLiked by 1 person
Cheers John
LikeLiked by 1 person
Very nice! I did immediately remind me the the little tower with the dragon in that was on the back of the “Creepy Coup” from the “Wacky Races” cartoon. 😁
Cheers Roger.
LikeLiked by 2 people
Cheers Roger
LikeLike
That is a great looking print and it’ll fit right in with the rest of the undead too!
LikeLiked by 1 person
Very impressive skeleton. Oh and the dragon ain’t bad either.
LikeLiked by 1 person
Cheers
LikeLike
That’s a big ‘ol Fell beast!
LikeLiked by 1 person
Very nice work on this guy Steve!!
LikeLiked by 1 person