Tonight I got these off the print bed… again two of the smaller vessels, but this time on the German side…

Destroyer left and Gunboat right. The destroyer has a torpedo rack aft.

The stands are being printed just now, so hopefully by tomorrow I will be able to show you them in their entirety. These take 2x1mm neodymium magnets to attach the weaponry, typically mine are all 3x1mm. I should have some with me soon, along with another bottle of resin.

These do need support and I sat them at an angle with the stern nearest the bed… you can play around with the angle, the British were done at 45 degrees and the German at about 40.

This was from the British print. I had forgotten to change the support settings, so I had 78% coverage and also heavy supports… not sure why…

I will check on the stands inba minute and get the next pair printing before bed.

Sadly no pikes tonight as I have a stinking tooth ache again. The pain killers eventually dulled it to a constant nagging discomfort. I will attempt to get to a dentist sometime soon.