So I got the Huey of the printer and my heart sank… the supports weighed more than the model, never a good sign.
The rotor is meant to be fastened to the drive rod thingy. It snapped off removing the supports. I wish I had made the closed door variant. This was the internal support.
The internal supports filled the whole cabin… bloody nightmare. It took 20 minutes to remove the internal supports.
So I think I need to redo this again and check the supports. Sadly Cura doesn’t show them. I may even hollow it out and do it on the resin one.
So as you can see he is a bit on the big side or the Huey is a bit on the small side.
I will have a play and see what I can come up with.
Bogenwald 
You could use it as a crashed Huey/scatter terrain. I also see a lot of people selling faulty prints online.
LikeLiked by 4 people
Oooo, I hate when that happens, especially after a long print. I recently went back to CURA, after a long time just not printing stuff, and noticed that supports are shown any more.
Oh, and have you tried “tree”supports? They use less material and longer to print, but are much easier to remove!
LikeLiked by 1 person
Yeah it was 18 hours. I couldn’t find the tree supports.
LikeLiked by 1 person
I’m running Cura 4.12.2, and you may have to selected to show it in the menu, but mine is under SUPPORT on the Support Structure list. Good luck!
LikeLiked by 1 person
Cheers Eric I will check it out tonight
LikeLiked by 1 person
It still looks pretty decent – certainly good enough for terrain as IRO suggests!
LikeLike