So after the total balls up of printing things yesterday (including printing the carriage body at 75% instead of 85%) I had some success with the supportless miniatures… all printed perfectly…

So it was definitely down to user error when the failures were happening..buoyed by this knowledge I set off again to print the stagecoach bits… I came back to this…

Nope, dear readers I hadn’t removed the body from the supports…this was it… so after a bit of head scratching and resin filtering I struck upon an idea, use the supported version as a reference for the angle of the piece as well as where the supports are… I eventually obtained the correct sized coach body 😁

Guess who snapped the coach light off!

I am now printing the underbody where the wheels will fasten to.

I also remembered to spray the other Arbites white too…

5 thoughts on “A Carriage for the Rich

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s