Well I got a bit more done on these little chaps…

It was mainly highlighting on the grey uniforms – not that you can tell from the photo…

The other bit of news is…

They now have a way to get down to a planet 😁

This took a very long time to print, but I got there in the end!

I have also had a mess around with 3D Builder and have made an extended 16 seater. According to Cura it will take 18 + hours to print. I added all the bits together in one ship apart from the roof and the rear hatch.

I also had a mess around making a lighter recon craft using the two engine pods and the nose cone. If I remember tomorrow I will get some shots of the STL files.

Back to work tomorrow…