Well tonight I downloaded the following…
Anyone got any ideas as to what it is???
This image was taken at the 2 hour 15 minutes stage… still about an hour to go. Probably not helped that I am evidently running at 90% speed (upped the speed to 100% now).This is printing at 0.15mm per layer with the infill set at 15%. The print speed is a bit slower being 40mm/S instead of the 60 I am used to.
I am paranoid that one or the other of them are going to fall over 😱 if this works I am going to try and print the Mausoleum overnight, that is if I can work out why the nozzle keeps getting covered in gunk.