Posted on by maenoferren22 · 11 Comments

Possessed Finished

Almost…

Well I cracked on this evening and got the possessed pretty much done.

I could do with adding a bit of shading onto the weapons. All in all I am quite pleased with these. I 3D printed a horde of skulls which I will add to the bases. I now have the ability to make my own tufts so I will see what coloured grass I have.

I also started printing some walls with railings…

I am rather pleased with these. Each section takes 1 hrs 22 minutes to print. I am thinking of going for a 3 x3 section which I will turn into a graveyard… the gateway below is from this set and to be honest looks too big, but I will see what they look like with it.

Posted on by maenoferren22 · 6 Comments

More Painting

Tonight we nearly had a bit of a disaster over dinner. Expected at 18.30 eventually got to eat it at 21.00. For some reason the gas stove decided to play silly buggers and decided that it would only cook at simmer temperatures. Luckily the roast pork was already cooked, everything else had to be cooked very, very slowly. Thankfully this did not happen when the power went off. I think it is the valve outside the house as all of the rings etc were the same.

After dinner I managed to get a bit more paint on the Possessed warband…

Still a fair old bit of white but I am getting there.

Posted on by maenoferren22 · 6 Comments

A Good Start to 2023

This evening I actually sat down and painted things.

Vae Victus cultists with Duncan Shadow Beastmen

I fully intended to paint the Witch Hunters, but these came out of the shelf first. Not a huge amount, but definitely a start.

The FDM printer has been busy too…this is where we are up to on the fortified gate.

I am printing one of the tower roofs now and once the second one is done then we will be onto the gate itself. The roof of the building detaches… it also has a slot for a portcullis inside.

Hopefully I shall carry on tomorrow, but with friends arriving at four then it may not be a huge amount.

Posted on by maenoferren22 · 6 Comments

Full Undead Ahead

I was chuffed this evening that I had got the undead all finished, I counted them then counted them again and suddenly realised I was missing someone. Yes, as I hadn’t used my list again then I had forgotten to print one of the most important characters in an undead force… the necromancer!

I had a mooch about, in case I had one, I did but it didn’t appeal to me as it was a skeletal necromancer. I decided that I wanted something different so chose a female miniature to act as my missing person. I will print her off during the day… this is the horde as it stands…

I also sliced the vampire in his human form, you know in case he wants to pop into Sigmar Haven for a quick bite.

I never got the Reikland lot sliced as I was too busy choosing a necromancer. Hopefully tomorrow.