Posted on by maenoferren22

Listening to Mick

Well Mr Jagger said ‘Paint it Black so I did…

My youngest wanted to have a go at “slap chop’ so I sprayed everything black including my combined harvester.

I fully intended to do a lot more this evening, but can you guess which pillock forgot to take his meds!

I did manage a smidge of something else…

I thought the big ‘Nid bases needed something on them. I, therefore, built a casualty in 3D builder. I then used Greenstuff to make the wound  (a wound sounds a little trite, for what has happened to this poor sod).

His back is flat to allow it to fit onto the base. I am hoping it will look more natural when it is embedded into the basing material.

Posted on by maenoferren22 · 6 Comments

Managed Some Painting

Well I made a start on a pair of the Erroish in Geek Club yesterday and managed to get them finished this evening. I also worked on the Spire big guy, and the other three for that matter

The big guy still needs the decoration done on his armour. I have decided to go for Gold as I feel this befits a super rich, nasty bully.

These are my pack beetles…

The saddles also had some failures, you can see an obvious one on the end of the front strap… Well actually it is a decorative border. But hey, either way it will get the Greenstuff  remedy.

Hopefully I will feel up to a bit more of the same tomorrow.

Posted on by maenoferren22

A Bit More Work

So this evening I worked on my Spyre Hunters.

The dude on the left as you may have noticed is not  futuristic hunter. He is a rat piper for my mate. He does have a tartan kilt, but to be honest I chose colours that were too dark so you cannot really see it.

I also added the big dude onto the newly printed base. I have also gone a bit daft and printed a couple of Desert gangers and some alien fauna. Well I didn’t just want to print a base on its own.

Posted on by maenoferren22

A Bit of Painting

Well I actually managed to get a tiny bit of painting done this evening.

I went for the unbased one to begin with.  He is going to have either red or yellow on the chest and knees.

The other two miniatures are for my youngest.  These two were the ones that failed yesterday. I did a plate re level and it worked fine second time around.

Posted on by maenoferren22 · 1 Comment

Out of the Painting Doldrums?

Well I seem to be in a bit of painting hole  at the minute. I really cannot be bothered to paint anything. This tiredness/pain thing is annoying in the extreme, so it makes motivation a bit hard.

However I found a set of miniatures that I am interested in actually painting. I remember having the full Spyre gang for Necromunda. I decided to try these from Print Miniatures.

For these I actually unboxed the new printer.

Because I am a pillock  I stuck three of the miniatures onto the wrong bases, it really only affects the one on the extreme left. She is leaping at an extreme angle. If you notice there is one of them on cardboard. This is because his base failed on the printer. Hopefully this is simple teething problem… however I tried a new print for my youngest and it failed.