I have looked at these for a while….

and eventually bit the bullet.

I had a quick play and am rather impressed with the results.

In the pack you get six ridged plates and two edges.

The ridged plates are large, medium and small. I only had a go at the large plates.

There aren’t any instructions on the box but to be honest the pieces fit together in only two ways.

Straight:

And angled (45 degrees)

Make a thinnish roll of Greenstuff…place on the bottom plate, slide the top plate back and forth until the desired result is obtained.

My results were pretty good straight off. Once or twice I pressed to hard and flattened the roll. This meant I needed to take it out and redo.

The bottom left was the first attempt.

The rest followed.

The nice thing is…you can redo it!

I did find the angled way a bit tricky…this was user error rather than equipment error.

I simply removed one edge piece and obtained instant success. It may be the case that this is what you need to do.

After playing with the kit for 10 minutes I had a hunt on YouTube and there is a fair bit out there to help. This is the first that came up.

Greenstuff Roll Maker

Am I happy with it… Yes I am. If pushed to give it a score out of 10 I would give it an 8 just on my initial play around. The third video in the series above shows how to make longer wigglers. There is however a larger version.

I got mine from the Greenstuff EBay shop at the price of £11.99. I am wanting to make Alien hive scatter terrain so it will be used quite a bit. In hindsight I should have got the larger version, which is only a pound cheaper, but at the time Of purchase I didn’t notice it..

My wife, however, is convinced that I have lost the plot. She can’t work out why I have purchased a tool for making caterpillars!🐛🐛🐛🐛