I hope!

So last night after having another failure I decided that enough was enough and that i Would relevel the bed. Good job I checked as although the front bolt was well and truly solid, thse side one was decidedly loose.

So I took out the resin, did a tank clean, which I had never done before and relevelled the plate. I gave some 40mm Gladiators another go. Yesterday I got two bodies and nothing else, today I got everything.

I am doing a reprint of the pair I printed the other day.

Hopefully I will get everything printed on that one too. Everything seems to have printed properly.

Today i did battle with the rotten floorboards in the lounge… i won, but it was a close run thing… This is the joys of a 200 year old house that has no foundations and everything sits directly on the ground (the floor is about 6 inches above the soil). After feeling quite proud of myself, I found some more that need replacing… i must admit i did say the off naughty word, especially as I had just nailed the replacements down. if i had noticed earlier my life would have been easier as i could have used the spaces i had made to eaily remove the extra bits…